Elegoo Neptune 4 Pro Initial Layer. ELEGOO Neptune 4 3D Yazıcı Background: the printer is a Neptune 4 Pro, using the newest Cura with a custom printer added 3.In [Preview] mode, slide the navigation bar on the right to view the number of layers that the model needs to pause at a specific layer, fill in the [Layer] box, and set the [X Position] [Y Position]
Elegoo Neptune 4 Pro from tweakreviews.com
Get the best out of your Neptune 4 (Pro) with the right settings Before setting the z-offset, the build plate and nozzle need to be heated up for a while (This video of a Neptune 4 Max shows it taking 25 minutes to stabilize, and although the Max build plate is larger, the same concept applies to the standard Neptune build plate)
Elegoo Neptune 4 Pro
If that goes wrong, then you might as well scrap that process and begin a new one. If that goes wrong, then you might as well scrap that process and begin a new one. If not lubricated regularly, it will cause wear and damage.
Comparison Table. I'm using PLA, bed is set to 65C (started having issues at the default 60C so I tried turning up the heat a bit), and the nozzle is set to 220C. Temperature is a running factor in all of these first layer issues; whether there's too much of it or too little of it, the printer will always develop first layer issues
Elegoo Neptune 4 Klipper 3D Printer Unbox & Setup YouTube. Background: the printer is a Neptune 4 Pro, using the newest Cura with a custom printer added NEPTUNE 4 PRO 3D Printer V1.5 Pictures are only for illustration purposes